Vennligst vent...
Produktet ble lagt i handlekurven. Se handlekurven her
47 93 82 00
Tom handlekurv

PLANET Konverter 10/100TX - 100FX SC SM Singlemode 100Mbit SC

Forsiden PC & NETTVERK Nettverk Nettverkstilbehør PLANET Konverter 10/100TX - 100FX SC SM Singlemode 100Mbit SC
Du må logge inn for å handle/se priser.
PLANET Konverter 10/100TX - 100FX SC SM Singlemode 100Mbit SC (FT-806A20)

PLANET Konverter 10/100TX - 100FX SC SM Singlemode 100Mbit SC

Varenummer:
FT-806A20
EAN:
4711213680571
  • Produkt Mediekonverterere
Beskrivelse

The PLANET FT-80X is Fast Ethernet Bridge 100Base-FX fiber to 10/100Base-TX shielded twisted pair (STP) converter. It supports selectable for half-duplex and full-duplex operations and supports a variety of fiber options. The converter auto-adapts to the highest level of performance supported by the device connected to the STP port. When the device is a switch or a workstation that supports full duplex, the converter adapts to the full-duplex mode and provides an effective 200Mbps bandwidth. When the connected device is a hub or a workstation that supports only half duplex, the converter adapts to the half-duplex mode and provides the nominal 100Mbps bandwidth. An override switch provides total manual control over the half/full-duplex operation, in fiber-optic interface. The fiber port of converter operates at 1310 nm and uses ST, SC, MT-RJ, VF-45 or WDM connectors. Multi-mode models that support distances up to 2 km and single-mode models that support distances up to 15/35/50 km are available.
The FT-80x series are with LFP (Link Fault Pass Through function) (LLCF/LLR) and the DIP Switch design. LLCF/LLR can immediately alarm administrators the problem of the link media and provide efficient solution to monitor the net. The DIP Switch provides disable or enable the LFP function.
LLCF (Link Loss Carry Forward) means when a device connected to the converter and the TP line loss the link, the converter's fiber will disconnect the link of transmit. LLR (Link Loss Return) means when a device connected to the converter and the fiber line loss the link, the converter's fiber will disconnect the link of transmit. Both can immediately alarm administrators the problem of the link media and provide efficient solution to monitor the net.

Product

Model

FT-80x

Protocol

IEEE 802.3u, 100Base-FX, 100Base-TX

Dimensions

70 x 97 x 26 mm (W x D x H)

Weight

0.2kg

Power

5V DC, 2A, max.

Connectors and Cables

Twisted Pair / STP

RJ45, Category 5 (EIA/TIA 568)

Fiber-optic

Vary on model;
X=1,2,3,4,5,6
1:ST
2:SC
3:MT-RJ
4:VF-45
6 Single SC; WDM

Multi-mode cable

50/125, 62.5/125 µm

Single-Mode (SM) cable

9/125 µm

Supported Distances and function

Twisted Pair STP

100 m / 328 ft.

Multi-mode Fiber Optic

412 m / 1,350 ft. (Half-Duplex)
2 km / 1.2 mile. (Full-Duplex)

Single-Mode (SM)

412 m / 1,350 ft. (Half-Duplex)
15 km / 9 mile. (Full-Duplex)
35km / 21 mile. (Full-Duplex)
50km / 31 mile. (Full-Duplex)

Port Mode

TP: Half and Full Duplex, auto-negotiation
FX: Half and Full Duplex via DIP switch

Environmental

Temperature

0 to 50 degrees C

Humidity

5-90% (non-condensing)



Selv om vi gjør vårt beste for å gi relevant informasjon, så er bildene kun for å gi et generelt inntrykk, og selve varen er ikke nødvendigvis akkurat slik som avbildet. Dersom det er forskjeller mellom produktoverskrift, beskrivelse og bilde, så er det produktoverskriften som gjelder (f.eks. PCer kommer ikke nødvendigvis med skjerm selv om bildet viser det). Hvis noe er uklart, vennligst send epost til kundestøtte før du bestiller. Vi tar forbehold om trykkfeil og endring av priser og spesifikasjoner uten varsel.